B&K CT310 Instrukcja Użytkownika Pobierz pdf (Strona 36)

CT600/602/610 and CT300/310 BKC-DIP Product Specific Appendices

Version 2.00.09

Updated 12/15/06

Page 36 of 48

Appendix L, X (executive) Commands

The following is a list of the supported Executive commands and details regarding their usage:

Recall Preset Command: (receiveID, X, 0, z=nn; cs16)

Zone z Preset nn is recalled to the current preset. Similar to the "G" get and “S” set commands,nn

can range from 00h – FDh, however it CANNOT be FFh for the current preset (as recalling the

current preset has no meaning).

NOTE: nn of FE is reserved for future expansion.

(00, X, 0, 1=4;cs16) Recall Zone 1 Preset 4 to current preset

(00, X, 0, 2=7;cs16) Recall Zone 2 Preset 7 to current preset

Save Preset Command: (receiveID, X, 1, z=nn, autoNameMode; cs16)

The current preset is saved to Zone z Preset nn. . Similar to the "G" get and “S” set commands, nn

can range from 00h – FDh, however it CANNOT be FFh for the current preset (as saving the

current preset has no meaning).

NOTE: nn of FE is reserved for future expansion.

(00, X, 1, 1=3;cs16) Save current preset to Zone 1 Preset 3

(00, X, 1, 2=9;cs16) Save current preset to Zone 2 Preset 9

The autoNameMode specifier can take on the following values with the following meanings:

0 Auto Name Preset, based upon state of System parameter Preset Auto

Naming

1 Do not Auto Name, regardless of System parameter Preset Auto

Naming

2 Force Auto Name, regardless of System parameter Preset Auto Naming

(00, X, 1, 1=8, 0;cs16) Save current preset to Zone 1 Preset 8

Auto Name based on Preset Auto Naming parameter

(00, X, 1, 1=8, 1;cs16) Save current preset to Zone 1 Preset 8

Do not Auto Name, preserve Preset Title

(00, X, 1, 1=8, 2;cs16) Save current preset to Zone 1 Preset 8

Force Auto Naming, overwriting Preset Title

NOTE: If Preset Auto Naming is active, the preset title will be overwritten.

NOTE: The autoNameMode specifier is optional. If it is omitted its value defaults to 0, so the

preset title is Auto Named based on the state of the System parameter Preset Auto

Naming.

Power State Command: (receiveID, X, 2, z=onOff; cs16)

Zone z’s power state may be controlled using this command. The onOff parameter may take on

the values of 1 or 0 for “on” or “off (Sleep)” respectively.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Brak uwag

B&K CT310 Instrukcja Użytkownika Strona 36