B&K 50 Series II Instrukcja Użytkownika Pobierz pdf (Strona 67)

11. The load will return to the Transient menu. Press to return to the normal display.

The Trig annunciator will appear and the display will look like below.

12. Depending on the selected Trigger Source from within the SYSTEM menu, the operation

may start immediately.

13. To run the transient operation, first press to enable the input. Then, send a

trigger to start the operation. If Trigger Source is set to Manual, press and then

to send a trigger. Refer to “Configure Trigger Source” in section “3.3 SYSTEM

Menu” to configure the Trigger Source.

Note: The number next to TRAN on display will count each transition. It can only count up

to 65535 transitions, after which it will reset to 0 and start over.

14. To disable transient operation, first press to disable the input. Then, press

and . Select Off and press to confirm.

80.000V

12.000A

0.00 W 00000.0S 1 TRAN

T r i g

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 101 102

Brak uwag

B&K 50 Series II Instrukcja Użytkownika Strona 67