B&K 50 Series II Instrukcja Użytkownika Pobierz pdf (Strona 39)

This parameter refers to the voltage low limit for the automatic test mode. During automatic

test mode, the DUT must be operating below the configured value for the test to PASS upon

completion. If the DUT operates above the configured value, the test will FAIL upon completion.

Note: This parameter is used for Automatic Test Function ONLY.

Setting CC, CV, CR, CW Mode

Follow the steps below to configure the mode and enable the load.

1. Press / / / (for CC/CV/CR/CW mode) so that it lights up.

2. Use the numeric keypad or the rotary dial to enter the desired setting value.

3. Use the and keys to change the cursor position to adjust different digits.

4. Press to enable the input.

3.3 SYSTEM Menu

All setup procedures and settings explained in this section can be accessed from the SYSTEM

menu. To access this menu, press and .

Restore Factory Default Settings

All instrument settings can be reset back to their factory default values by doing the following:

SYSTEM MENU

Initialize Power -ON Buzzer

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 101 102

Brak uwag

B&K 50 Series II Instrukcja Użytkownika Strona 39